Self-Adhesive Patch Inner Tube Repair Kit

1.Remove the inner tube and locate the puncture2. Roughen the area around the puncture using the sandpaper3. Clean and dry this area4. Apply the self-adhesive patch and press hard on the entire area for around 45 seconds5. Run your nail over the patch to increase its adhesive power6. Put the inner tube back in the tyre and the tyre in the rim7. Inflate your tyre to the recommended pressure.

Optimal lifespan:3 years at room temperature (16-22°C, 30-70% humidity), away from direct light, in original packaging.Minimum temperature for repairs: +10°CTemperature for use: -40°C to +65°C

Be careful not to touch the sticky part when positioning the patch, so as not to reduce its sticking power.Remove any air bubbles from the centre of the patch towards the edges.Rub the patch with your nail to warm it up and help it stick better.Finally, press firmly with your thumb, covering the entire patch for 45 seconds to 1 minute (press on a clean, flat surface for greater effectiveness).

A good sanding of the area concerned will give you a better result.The aim is to obtain a flat, clean surface so the patch holds as well as possible.If the puncture is close to excess material, sand until the excess is removed.Sanding will create micro-scratches that will allow the glue on your patch to set more easily.This stage is very important for a lasting repair.

Clean away any impurities to ensure a clean, flat and dry area to apply the patch.Remember: don't use water or any other product to clean your inner tube after sanding. It's essential to have a clean, dry surface to ensure that your patch lasts.

To make sure that your patch remains in place for as long as possible on your repaired inner tube, we strongly recommend that you reinflate your inner tube within 24 hours of applying the patch and that you inflate it to the recommended pressure.